SET-UP INSTRUCTIONS

 

Step 1

Locate the area where the tent is to be erected. Choose a spot that is level and flat free from

sharp object. Remove the tent from carrybag and make sure all parts are accounted.

 

Step 2

 

Place the tent in a vertical position with all poles pointing upward and spread out the rolled tent

fabric. Untie the Velcro strap and release the poles free around the center hub like a star.

 

Step 3  ERECT THE TENT

 

Insta-set poles are pre- assembled to the tent as an integral part like an umbrella.

Lifting the tent assembly with holding center hub, shake the tent gently to allow all 6 pole lines to

hang down. Make sure the fabric of the tent isnt caught between the center hub and connecting poles.

(If fabric gets caught, lower the center hub until fabric is released. Do not try to tug or pull fabric

free as damage to fabric is possible.)

 

Start locking the first pole into position. While one person holds the tent assembly as high as

possible, another grasps the pole approximately two inches above the upper joint with one hand

and about one foot from the bottom of the upper joint with the other hand. Push down with top

hand while pulling up with the other hand until the upper joint snaps. The lower joint is locked

into position automatically when the upper joint is locked. After locking the first pole into position, repeat

this step until the entire tent is set up.

Drive stakes through stake loops into the ground.

 

Step 4  INSTALL THE RAINFLY

 

Insert one end of the pole into the pole pocket. Gently flex the pole and place the opposite pole

end into the other pole pocket. Secure the rainfly to the pole by tying the tie strings around the

pole.

 

Drape the rainfly over the tent roof, placing hood cut over the door. Hook S hooks into the

D-rings of the plastic stake loops. Secure the rainfly to the tent by tying attached tie tapes. Tent

may be guyed if a high wind is expected.

 

 

T A K E    D O W N

 

Step 1

 

Follow reverse step of the tent set-up instructions. Unzip door and window. Remove any sharp

objects inside the tent. Do not remove the stakes from the ground by pulling the stake loops.

This may cause a tear out of the seam to the stake loops. Remove the stakes, guy ropes, rainfly and

divider from the tent. Remove and disassemble the shock-corded pole for the rainfly.

 

Step 2

 

To collapse insta-set poles, release the upper joint by pushing down the upper part of the upper

joint and sliding down the lower collar of the upper joint simultaneously. If the lower collar does not

slide down easily, push down the upper part of the upper joint a little more. While releasing the

upper joint, another person may help by holding the center hub in raised position.

Unlocking the upper joint allows the lower joint to collapse Automatically.

    (If the lower joint sticks into locked position While collapsing the tent, pick up the upper

        pole section of the lower joint and shake gently until lock releases.)

Unlocking the upper joint allows the lower joint to collapse Inwardly and the upper pole section

of the lower joint to fall down over the lower pole section of the lower joint. Repeat this step

until the entire the tent is collapsed.

 

Step 3

 

Align the tent assembly like a star, keeping the tent frames radiating from the center hub. To roll

the tent, gather together the poles like an umbrella assembly, tie together the end of the poles

by Velcro strap and trim the tent fabric like figure <step2> of the tent set-up instructions.

Lay the tent on the ground and press any trapped air inside the tent. Fold up the tent fabric over

the poles and roll the tent to its minimum size.

NOTE : If the poles are not in correct position, do not force them but unfold and realign the

poles before proceeding.

 

Step 4

 

Pack the tent into carrybag together with the shock-corded pole, divider, rainfly, accessories

and instruction sheet.